Arm the track to record and you should see an input signal from the mixer.In, second drop down will be input patch that needs to correspond to the channel you're sending from the mixer if the channel isn't shown, select the Configure button and assign the mono/stereo channel patch points.
#Configure usb overdrive mac back forward install#
Download & Install the Multi-Channel USB Driver from the Soundcraft website.First 10 channels are your Masters (L, R, Aux Buses 1-8), so the input channels start at patch point 11. No USB send patching is required on the Ui24R's end, it automatically is set, however, the input patching in your DAW is somewhat tricky. In order to achieve playback/recording simultaneously, go to System Preferences on your MAC and make sure the Ui24R is selected as your input & output (playback) device.You should see an input signal from the mixer. Create a new audio track in your session and change its input patch to the corresponding channel on the mixer.Select the Output tab in the I/O window, highlight all audio pathways pictured and delete them, select the Default button to re-config with the proper I/O.Select the Input tab in the I/O window, highlight all audio pathways pictured and delete them, select the Default button to re-config with the proper I/O.Power on the Ui24R, Open new ProTools session after power up (Sample Rate NEEDS to be 48kHz).Start with mixer powered off, connect mixer to MAC via USB.
0 kommentar(er)
